Orion-system PT-Link II LON Manual do Utilizador descarregar pdf (Página 17)

PT-Link II Interface

PT-Link II LON

Technical Guide

Programming the PT-Link II with

BootLoader

The PT-Link II is equipped with the ability to update its software with

the use of a computer. You will need the following before you begin:

• PT-Link II in need of an update (powered up,

no other connections necessary)

• Computer running Microsoft Windows

operating

system

• Prism II software from www.orioncontrols.com/software-

new.html

• Latest version of PT-Link II software (e-mailed from our

tech support staff or downloaded from any of our websites)

and software sheet

• USB Driver Setup.exe ﬁ le located on PT-Link II CD or

downloaded from any of our websites

• USB cable

Follow these simple steps to update the PT-Link II:

1.) Turn on your computer and download the latest Prism II software

from www.orioncontrols.com/software-new.html.

2.) Either download the PT-Link II update ﬁ le from http://techsupport.

wattmaster.com or save the ﬁ le to your computer from the e-mail you

received from Tech Support. Record the path and name of the ﬁ le for

later use. Also, print the software sheet provided for future reference.

3.) Run the USB Driver Setup.exe ﬁ le (found on the PT-Link II CD or

downloaded from any of our websites) so that Prism can communicate

to the PT Link II. Unzip the ﬁ le to the directory where you saved your

PT-Link II software.

4.) Plug the USB cable into the computer’s and PT-Link II’s USB

ports.

5.) A message will pop-up from the lower menu bar of Windows that

reads, “Found New Hardware.” Click on this message and follow the

instructions that appear to install the USB drivers.

6.) Open Prism 2 and Login with the User Name, admin and the Pass-

word, admin. If successful, “Administrator Access” will appear at the

lower right of the Prism program.

NOTE: If using a Prism 2 version

prior to 4.0, the Login is ﬂ ash. If successful, “Level 4 Access” will ap-

pear at the lower right of the Prism program.

7.) Click on the <Job-Site> icon. The Job-Sites Window will appear.

In the Type of CommLink Dialog Box, select “Hi Speed CommLink.”

8.) In the Job-Sites Window, from the Serial Port drop down list, select

the correct COM port. If you don’t know the COM port number or if the

number is 10 or higher, follow the directions on pages 19-20.

9.) From Prism II’s Communications tab, select “Flash Selected

Controller.”

10.) The Flash Controller Window will appear.

11.) From the Flash Controller Window’s Connection tab, select

“Direct”. Keep the Flash Controller Window open.

12.) Cycle power to the PT-Link II and within 5 seconds, click the

<Get Info> button in the Flash Controller Window. The PT-Link II in-

formation will now appear in the window under the

<Get Info> button.

Revised 7/28/14

Updating the PT-Link II Controller

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 59 60

Comentários a estes Manuais

Sem comentários

Orion-system PT-Link II LON Manual do Utilizador Página 17

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Orion-system PT-Link II LON