Orion-system MUA II D Controllers Operator Interfaces Manual do Utilizador Página 1

Operator InterfacesTechnical Guide( SS1013 or Y200405 MUA II D Controller Code)(Use SS1010 System Manager Code & SS1009 Service Tool Code)www.orio

Technical GuideOperator Interfaces10Note: The second line displays which day of the week is cur-rently being programmed. This automatically increment

Operator Interfaces Technical Guide11Normally the holidays will operate in an unoccupied mode or a reducedschedule mode. There are two start/stop even

Technical GuideOperator Interfaces12General Programming Informationcontroller on the system and press "Enter". The following screen willapp

Operator Interfaces Technical Guide13Programming The MUA II D ControllerConfigurationIn order to correctly setup the MUA II D controller you must firs

Technical GuideOperator Interfaces14Programming The MUA II D ControllerConfiguration Screen #7MUA II Cnfg IDxxxx Broadcast Humidity Reading :_NO

Operator Interfaces Technical Guide15from the Supply Air Setpoint gives the Unoccupied Heating ModeSetpoint. When the Space Air Temperature drops bel

Technical GuideOperator Interfaces16Setpoint Screen #9MUA II Spts IDxxxxSet Sat Temp Reset SPC= xxx Spt= xxx SPC= xxx Rst= xxxA Type III Thermist

Operator Interfaces Technical Guide17Setpoint Screen #16 MUA II Spts IDxxxxPush-Button OverrideDuration : x.x HrIf the Space Temperature sensor con

Technical GuideOperator Interfaces18StatusThe MUA II D controller status screens are accessed by pressing the“Status” button on either the System Ma

Operator Interfaces Technical Guide19Status Screen 8-27MUA II vx.xx IDxxxxFan Relay : OFFCool Stage1 : OFFHeat Stage1 : OFFLine 2 - Curren

Table Of ContentsIntroduction ...

Technical GuideOperator Interfaces20Outputs ForceOutput Force settings are available for testing or troubleshooting thesystem. These Force settings

Operator Interfaces Technical Guide21Notes:

Technical GuideOperator Interfaces22Notes:

Operator Interfaces Technical Guide23Notes:

Form: OR-MUAIID-SMST-TGD-01C Printed in the USA December 2004All rights reserved Copyright 2004WattMaster Controls Inc. • 8500 NW Riv

Operator Interfaces 3 Technical GuideModular System ManagerENTERCLEARESCPREVNEXTDOWNUP654DEC7081329MINUS-STATUSSETPOINTSSCHEDULESALARMSOVERRIDES9.00&q

Technical GuideOperator Interfaces4Modular Service ToolWether you have a Stand Alone, Interconnected or Networked OrionControls System, the Modular S

Operator Interfaces Technical Guide5Modular System ManagerAs previously described, when you are connecting the Modular SystemManager to a Networked

Technical GuideOperator Interfaces6General Programming InformationThe Modular Service Tool or the System Manager allow the user toview any temperatur

Operator Interfaces Technical Guide7Modular System ManagerSystem Manager Initialization ScreensWhen the System Manager is powered up, the first screen

Technical GuideOperator Interfaces8Configuring The Modular Service Tool ForNetwork Or Stand-Alone OperationAs with the System Manager described previ

Operator Interfaces Technical Guide9EXAMPLE #2You would like to view the 12th controller on the 24th loop. Enter “2412”as the Unit IDEXAMPLE #3You wou